Discussion about problems you may have with KORG PA Manager.
6 posts • Page 1 of 1
I tried to load a Pa4X performance set (PRF) that I purchased from an internet site. 3 of the performances failed to load correctly. All other performances in the PRF set loaded correctly. Each of the performances that failed to load showed <Sound Not Found> 255,255,255 for UP1, UP2, UP3 and Low. When I loaded this PRF on the Pa4X I noticed that what they had in common was they all used the DRAWBARS sound for one of the sounds. The strange thing is that all sounds within that same performance also showed <Sound Not Found> even though these sounds were found in other performances. They are all default factory sounds. So my questions are how can I load a performance that uses the factory DRAWBARS sound and how can I set the properties for the drawbar sound (Drawbar position, rotary, etc..).